Toro Groundsmaster 7210 Service Manual page 311

Removing the Idler Assembly (continued)
Installing the Idler Assembly
Groundsmaster 7210
16222SL Rev C
4. Loosen the 2 jam nuts (item 22 in
the cutting deck to allow clearance between the idler arm and stop bolt.
5. Remove the drive belt from the deck pulleys.
6. Insert a nut driver or small piece of pipe onto the torsion spring end of the
idler arm.
The spring is under heavy load and can cause personal injury.
Be careful when removing the tension from the torsion spring of
the idler arm.
7. Carefully push the torsion spring end down and away from the idler arm
to unhook the spring from the arm.
8. Remove the snap ring that retains the idler arm assembly to the cutting deck.
9. Remove the idler components as shown in
1. Install the idler components that were removed, and secure the idler arm
assembly to the cutting deck with the snap ring
2. Insert a nut driver or small piece of pipe onto the torsion spring end of the
idler arm.
The spring is under heavy load and can cause personal injury.
Be careful when applying the tension to the torsion spring of the
idler arm.
g033712
1. Idler arm
2. Stop bolt
Figure 217) that attach the idler stop bolt to
CAUTION
Figure
CAUTION
Figure 218
3. Jam nut
Page 7–7
217.
(Figure 217).
Cutting Deck: Service and Repairs