Toro Groundsmaster 7210 Service Manual page 278

Disassembling the Parking Brake Assembly (continued)
Assembling the Parking Brake Assembly
Chassis: Service and Repairs
g033686
1. Left cover
2. Remove the 2 bolts (item 2 in
machine, and remove the left cover.
3. If necessary, remove the brake handle (item 1 in
A. On both sides of the machine, remove the hairpin cotter and clevis pin
from the brake linkage yoke.
B. Support the brake handle to prevent it from shifting or falling.
C. Remove the 4 screws and 4 nuts that attach the flange bearings to the
frame.
D. Remove the brake handle and flange bearings from the machine.
4. Remove the additional parking brake components as shown in
g033687
1. Front brake rod
2. Hex nut
1. Assemble the parking brake components as shown in
A. If the brake linkage yoke was removed from the front brake rod, install the
yoke onto the rod so that the center-to-center length is 21.1 to 21.2 cm
(8.290 to 8.350 inches)
B. Ensure that the screws (item 10 in
the flange bearings to the frame are installed from the outside of the
frame to the inside.
Figure 193
2. Bolt (2 each)
Figure 193) that attach the left cover to the
Figure 194
3. Brake linkage yoke
(Figure 194).
Figure
Page 6–16
Figure 192) as follows:
Figure
Figure 192.
192) that are used to attach
Groundsmaster 7210
16222SL Rev C
192.