Toro Groundsmaster 7210 Service Manual page 303

Installing the Hood
Groundsmaster 7210
16222SL Rev C
1. Install all the hood components that were removed
Note: If the intake screen was removed from the hood, ensure that the hood
support, seal plate are attached to the hood before you install the screen.
2. Attach the screen to the hood with the 26 plastic plugs.
3. Check the condition of all the seals on the frame and hood. Replace the
damaged or missing seals.
4. Check that no gaps exist between the hood components and the machine
frame.
Note: If necessary, seal the gaps with silicone sealant.
5. Position the hood to the machine and slide the hood support onto the frame
rods.
6. Secure the hood to the frame rods with the hairpin cotter (item 17 in
215).
7. Close the hood and latch it.
Page 6–41
(Figure 215).
Figure
Chassis: Service and Repairs