Toro Groundsmaster 7210 Service Manual page 51

Removing the Fuel Tanks (continued)
Installing the Fuel Tanks
Groundsmaster 7210
16222SL Rev C
g036995
1. Flange-head screw (5 each)
2. Control panel
3. Locknut (2 each)
11. At the right fuel tank, remove the 5 flange-head screws (item 1 in
that secure the control panel to the right fuel tank. Carefully position the
control panel away from the fuel tank.
12. Loosen and remove the 2 screws, 2 clamps, and 2 flange nuts (items 32, 25,
and 26 in Figure 14) that secure each fuel tank to the frame of the machine.
13. Loosen and remove the screws (items 18 and 30 in
plain washers, rubber washers, and flange nuts that secure the fuel tanks
to the frame of the machine.
14. Lift the fuel tank from the machine.
15. Locate and retain the spacer (items 29 and 15 in
Note: For information regarding the fuel pump testing; refer to
Pump (page 5–43).
Note: Refer to the Traction Unit Operator's Manual for the fuel/water separator
and fuel filter service information.
1. If the strainer fitting was removed from the fuel tank, perform the following:
A. Clean the threads of the fuel tank and strainer fitting.
B. Apply a coat of fuel resistant thread sealant to the threads of the strainer
fitting.
C. Install the strainer fitting into the fuel tank and tighten the strainer.
2. If the elbow and straight fittings (items 43 and 44 in
from the fuel/water separator head, apply thread sealant to the fittings before
installing.
Figure 15
4. Control panel cover
5. Swell latch (2 each)
Page 3–19
G036995
Figure
Figure 14), flat washers,
Figure 14) from the fuel tank.
Testing the Fuel
Figure 14) were removed
Diesel Engine: Service and Repairs
15)