Toro Groundsmaster 7210 Service Manual page 164

Assembling the Transmission (continued)
Hydraulic System: Service and Repairs
g033475
1. Filter bypass valve
52. Lubricate the filter bypass valve and spring with clean hydraulic fluid and
install them into the pump body.
53. Lubricate new O-ring and install the O-ring onto the plug. Install the plug into
the pump body; torque the plug to 23 to 26 N∙m (17 to 19 ft-lb).
g033476
1. Sleeve
2. Spool
3. Pin
4. Sleeve holes
54. Lubricate the solenoid valve spring, sleeve, and spool with clean hydraulic
fluid and install the solenoid valve spring, sleeve, and spool into the pump
body.
Note: Ensure that the sleeve is installed so that the holes are closest to the
spring location and that the step in the spool is also toward the spring location.
Figure 115
2. Filter bypass plug
Figure 116
5. Spool step
6. Solenoid valve stem
7. Solenoid coil
Page 4–104 Groundsmaster 7210
16222SL Rev C