Suzuki SY413 Service Manual page 2878

6. Connecting rod
1. Top ring bearing cap
2. 2nd ring 7. Connecting rod
3. Oil ring bearing
4. Piston 8. Piston pin
5. Connecting rod 9. Piston pin circlip
1. Guide hoses
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-49
PISTON, PISTON RINGS, CONNECTING
RODS AND CYLINDERS
REMOVAL
1) Remove cylinder head from cylinder block as previously out-
lined.
2) Install engine right mounting bracket.
3) Drain engine oil.
4) Remove oil pan and oil pump strainer as previously outlined.
5) Mark cylinder number on all pistons, connecting rods and rod
bearing caps, using silver pencil or quick drying paint.
6) Remove rod bearing caps.
7) Install guide hose over threads of rod bolts.
This is to prevent damage to bearing journal and rod bolt
threads when removing connecting rod.
8) Decarbon top of cylinder bore before removing piston from cyl-
inder.
9) Push piston and connecting rod assembly out through the top
of cylinder bore.