Suzuki SY413 Service Manual page 2846

TIMING BELT AND BELT TENSIONER
1. Engine under cover (RH)
1. Engine right mounting bracket
2. Engine right mounting bracket stiffener
REMOVAL
1) Disconnect negative cable at battery.
2) Remove right side of engine under cover.
3) Remove A/C compressor, P/S pump and drive belt with hoses
still attached, if equipped.
NOTE:
Suspend removed A/C compressor and P/S pump at a
place where no damage will be caused during removal and
installation of timing belt and belt tensioner.
4) Support engine by using lifting device.
5) Remove air cleaner case with air cleaner outlet hose.
6) Remove engine right mounting bracket and stiffener.
7) Remove water pump pulley and drive belt.
1. Water
pump
pulley
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-17
1. Timing belt
2. Tensioner
3. Tensioner plate
4. Tensioner spring
5. Camshaft timing pulley
6. Tensioner bolt
7. Pulley bolt
8. Seal
9. Inside cover seal
10. Inside cover
11. Outside cover seal
12. Outside cover
13. Tensioner stud
14. Dowel pin
15. Crankshaft pulley