Suzuki SY413 Service Manual page 2855

6A1-26 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Rotor plate
2. Inner rotor
3. Outer rotor
4. Gasket
5. Pin
1. Mounting member
2. Engine front torque bush
3. Engine rear mounting
4. Body
OIL PUMP
6. Pin
7. Relief valve
8. Spring
9. Retainer
10. Retainer ring
REMOVAL
1) Disconnect negative cable at battery.
2) Remove timing belt as previously outlined.
3) Remove generator and its bracket.
NOTE:
When installing bracket, tighten nut (A) first.
4) Remove power steering pump bracket or A/C compressor
bracket, if equipped.
5) Remove oil pan and oil pump strainer as previously outlined.
6) Install mounting member (2WD only).
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
(b): 45 N·m (4.5 kg-m, 32.5 lb-ft)