Chrysler PT Cruiser 2001 Service Manual Supplement page 2851

P1776-SOLENOID SWITCH VALVE LATCHED IN LR POSITION —
Continued
TEST
2 With the DRBIII , check for other transmission DTC's
Is P-code 1784 Present also?
Yes → Refer to symptom list and perform test for DTC P-1784.
→ Go To 3
No
3 Perform a visual inspection of all connectors, wiring, and cooler connections before
proceeding. Repair as necessary.
With the DRBIII , Check the STARTS SINCE SET counter.
Note: This counter only applies to the last code set.
Is the STARTS SINCE SET counter 2 or less?
Yes → Go To 4
→ Go To 12
No
4 Turn ignition off to the lock position.
CAUTION: Remove the Starter Relay from the PDC. This will prevent the
vehicle from being started in gear.
Install Transmission simulator (Miller tool #8333) and the FWD Adapter Cable
kit.(Miller tool #8333-1).
Ignition on, engine not running.
Using the Transmission Simulator, set the pressure switch selector knob to the L/R
position.
While observing the L/R pressure switch state with the DRBIII , depress the
Pressure Switch Test button.
Did the pressure switch state on the DRB change from open to closed when the switch
was depressed?
Yes → Go To 5
→ Go To 7
No
5 The transmission must be above 70 degree F. prior to checking fluid level. Adjusting
fluid level on a cold transmission will result in an overfilled transmission.
Check the transmission fluid level per the service information.
Is the fluid level OK?
Yes → Go To 6
→ Adjust fluid level. Repair cause of incorrect fluid level.
No
6 The transmission has an internal problem and must be repaired.
If the trans is to be repaired, inspect the Solenoid Switch Valve in the valve body per
the service manual instructions and repair or replace as necessary. If no problems are
found in valve body, replace the transmission solenoid/pressure sw assembly.
Note: The Solenoid Switch Valve should move back and forth freely.
View repair options.
Repair
ACTION
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
Repair internal transmission problem as necessary.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
103
TRANSMISSION
APPLICABILITY
All
All
All
All
All