Chrysler PT Cruiser 2001 Service Manual Supplement page 2442

23 - 10 STATIONARY GLASS
QUARTER WINDOW
REMOVAL
Refer to the Windshield Removal procedure for a
description of tools and adhesive systems that are
recommended for use in this procedure.
(1) Open liftgate
(2) Remove C & D Pillar upper trim panel (Fig. 9).
(3) Remove lower quarter trim panel as necessary
(Fig. 10).
(4) Remove nuts attaching quarter window glass.
(Fig. 11).
WARNING: WEAR EYE AND HAND PROTECTION
WHEN HANDLING SAFETY GLASS. PERSONAL
INJURY CAN RESULT.
CAUTION: Do not damage body or trim finish when
cutting out glass or applying fence primer.
(5) Remove the quarter window glass from the
vehicle by pushing on glass from inside of vehicle.
Fig. 9 Quarter Trim Panel
1 – C-PILLAR UPPER TRIM PANEL
2 – REAR QUARTER PANEL
3 – D-PILLAR UPPER TRIM PANEL
4 – QUARTER LOWER TRIM PANEL
5 – JACK STORAGE ACCESS DOOR
6 – QUARTER TRIM PANEL LOWER PLUG
7 – VERTICAL BUMPER
8 - SEAT LATCH STRIKER COVER
2001 PT CRUISER
1 – REAR QUARTER PANEL
2 – REAR QUARTER TRIM PANEL
3 – CARGO TIE DOWN QUARTER TRIM LOWER LOOP
INSTALLATION
(1) Prepare window fence by removing exsisting
butyl.
(2) Remove butyl release paper on quter glass.
(3) Place quarter window glass into position.
(4) Install quarter window glass attaching nuts.
(5) Water test quarter window glass to verify
repair.
(6) Install lower quarter trim, and C& D-Pillar
trim (Fig. 9) and (Fig. 10).
(7) Close liftgate.
Fig. 10 Lower Quarter Trim
PT