Chrysler PT Cruiser 2001 Service Manual Supplement page 2710

VERIFICATION TESTS
Verification Tests
41TE TRANSMISSION VERIFICATION TEST - VER 1
1. Connect the DRBIII to the Data Link Connector (DLC).
2. Reconnect any disconnected components.
3. With the DRBIII , erase all Transmission DTC's, also erase the PCM DTC's.
4. With the DRBIII , display transmission temperature. Start and run the engine until the
transmission temperature is HOT (above 110 deg. F).
5. Check the transmission fluid and adjust if necessary. Refer to the Service information for the
Fluid Fill procedure.
6. NOTE: If the Transmission Control Module or torque converter has been replaced
or if the transmission has been repaired or replaced it is necessary to perform the
DRBIII Quick Learn Procedure and reset the Pinion Factor
7. Road test the vehicle. With the DRBIII , monitor the engine RPM. Make 15 to 20 1-2, 2-3,
3-4 upshifts. Perform these shifts from a standing start to 45 MPH with a constant throttle
opening of 20 to 25 degrees.
8. Below 25 MPH, make 5 to 8 wide open throttle kickdowns to 1st gear. Allow at least 5 seconds
each in 2nd and 3rd gear between each kickdown.
9. For a specific DTC, drive the vehicle to the Symptom's When Monitored/When Set conditions
to verify the DTC repair.
10. Check for Diagnostic Trouble Codes (DTC's) during the road test. If a DTC sets during the
road test , return to the Symptom list and follow the path.
11. NOTE: Erase P0700 DTC in the PCM to turn the MIL light off after making
transmission repairs. This will turn the MIL off.
Were any Trouble Codes set during the road test?
Yes → Refer to the Symptom List for appropriate diagnostic tests.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
→ Repair is complete.
No
250
APPLICABILITY
All