Chrysler PT Cruiser 2001 Service Manual Supplement page 2696

TRANSMISSION
P0833-CLUTCH RELEASED SWITCH CIRCUIT —
TEST
3 Turn the ignition off.
Disconnect the Clutch Interlock/Upstop Switch harness connector.
Using a 12-volt Test Light connected to 12-volts, check the Clutch Interlock/Upstop
Switch Ground circuit.
Did the test light illuminate brightly?
Yes → Go To 4
→ Repair the Clutch Interlock/Upstop Switch Ground circuit for an
No
4 Turn the ignition off.
Disconnect the Clutch Interlock/Upstop Switch harness connector.
Disconnect the PCM harness connectors.
Measure the resistance of the Clutch Upstop Signal circuit.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the open Clutch Upstop Signal Circuit.
No
5 Turn the ignition off.
Disconnect the Clutch Interlock/Upstop Switch harness connector.
Disconnect the PCM harness connectors.
Measure the resistance between ground and the Clutch Upstop Switch Signal circuit.
Is the resistance above 100k ohms?
Yes → Go To 6
→ Repair the Clutch Upstop Switch Signal circuit for a short to
No
6 Disconnect the Clutch Interlock/Upstop Switch harness connector.
Connect a jumper wire between the Clutch Interlock/Upstop Switch Ground circuit
and the Clutch Upstop Switch Signal circuit in the Clutch Interlock/Upstop Switch
harness connector.
Using the DRB, monitor the Clutch Upstop Switch status in Input/Outputs.
Did the Clutch Upstop Switch status change from Open (jumper disconnected) to
Closed?
Yes → Replace the Clutch Interlock/Upstop Switch.
→ Go To 7
No
7 If there are no possible causes remaining, view repair.
Repair
ACTION
open or high resistance.
Perform TRANSMISSION DTC VERIFICATION TEST.
Perform TRANSMISSION DTC VERIFICATION TEST.
ground.
Perform TRANSMISSION DTC VERIFICATION TEST.
Perform TRANSMISSION DTC VERIFICATION TEST.
Replace the Powertrain Control Module.
Perform TRANSMISSION DTC VERIFICATION TEST.
Continued
236
APPLICABILITY
5SPD MANUAL
TRANS
5SPD MANUAL
TRANS
5SPD MANUAL
TRANS
5SPD MANUAL
TRANS
5SPD MANUAL
TRANS