Chrysler PT Cruiser 2001 Service Manual Supplement page 2690

STARTING
*NO CRANK CONDITION —
TEST
14 Disconnect the Clutch Interlock/Upstop Switch harness connector.
Connect a jumper wire between the Clutch Interlock/Upstop Switch Ground circuit
and the Clutch Interlock Switch Signal circuit in the Clutch Interlock/Upstop Switch
harness connector.
Using the DRB, monitor the Clutch Switch status in Input/Outputs.
Did the Clutch Switch status change to Closed?
Yes → Replace the Clutch Interlock/Upstop Switch.
→ Go To 15
No
15 If there are no possible causes remaining, view repair.
Repair
Continued
ACTION
Perform TRANSMISSION DTC VERIFICATION TEST.
Replace the Powertrain Control Module.
Perform TRANSMISSION DTC VERIFICATION TEST.
230
APPLICABILITY
5SPD MANUAL
TRANS
5SPD MANUAL
TRANS