Chrysler PT Cruiser 2001 Service Manual Supplement page 2647

P1495-LEAK DETECTION PUMP SOLENOID CIRCUIT —
TEST
13 At this time, the conditions required to set the DTC are not present.
Note: Use the Freeze Frame Data to help you duplicate the conditions that
set the DTC. Pay particular attention to the DTC set conditions, such as,
VSS, MAP, ECT, and Load.
Note: Visually inspect the related wiring harness. Look for any chafed,
pierced, pinched, or partially broken wires.
Note: Visually inspect the related wire harness connectors. Look for broken,
bent, pushed out, or corroded terminals.
Note: Refer to any Technical Service Bulletins (TSB's) that may apply.
Perform a wiggle test of the LDP wiring while the circuit is actuated with the DRB.
Listen for the LDP to quit actuating. Also watch for the Good Trip Counter to change
to 0.
Were any problems found?
Yes → Repair wiring harness/connectors as necessary.
→ Test Complete.
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 6.
DRIVEABILITY - GAS
187
Continued
APPLICABILITY
All