Chrysler PT Cruiser 2001 Service Manual Supplement page 2717

Verification Tests —
1. Reconnect all previously disconnected components and connectors.
2. Obtain the vehicle's unique Personal Identification Number (PIN) assigned to it's original
SKIM. This number can be obtained from the vehicle's invoice or Chrysler's Customer Center
(1-800-992-1997).
3. NOTE: When entering PIN, care should be taken because 3 attempts will only be allowed.
The SKIM module will then lock out the DRB III for 1 hour, which will cause the DRB III to
display Bus +\- Signals Open' to SKIM.
4. To exit lock out mode, the ignition key needs to remain in the On position continually for
one hour. Turn off all accessories and connect a battery charger, if necessary.
5. With the DRB III, select Theft Alarm,
procedure and follow the steps displayed.
6. If the SKIM was replaced, ensure all of the vehicles keys are programmed into the new
SKIM.
7. Note: Prior to returning vehicle to the customer, perform a module scan to be sure
all DTC's are erased. Erase ANY DTC's that are found.
TRANSMISSION DTC VERIFICATION TEST
1. Inspect the vehicle to ensure that all engine components are properly installed and
connected. Reassemble and reconnect components as necessary.
2. If any existing diagnostic trouble codes have not been repaired, go to Symptom List and
follow path specified.
3. Connect the DRBIII to the data link connector.
4. Ensure the fuel tank has at least a quarter tank of fuel. Turn off all accessories.
5. Perform steps 6 through 8 if the PCM has been replaced. Then proceed with the verification.
If the PCM has not been replaced skip those steps and continue verification.
6. If PCM has been changed and correct VIN and mileage have not been programmed, a DTC
will be set in ABS and Air bag modules. In addition, if vehicle is equipped with a Sentry Key
Immobilizer Module (SKIM), Secret Key data must be updated to enable start.
7. For ABS and Air Bag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS
and Air Bag modules.
8. For SKIM theft alarm: Connect DRBIII to data link conn. Go to Theft Alarm, SKIM, Misc.
and place SKIM in secured access mode by using the appropriate PIN code for this vehicle.
Select Update the Secret Key data. Data will be transferred from SKIM to PCM.
9. Start and run the engine until the transmission temperature is above 43°C (110°F).
10. Check the transmission fluid level. Adjust if necessary.
11. Road test the vehicle. Make 15 to 20 1-2, 2-3 and 3-4 up shifts. Perform these shifts from
a standing start to 72 kmh (45 mph) with a constant throttle opening of 20-25%.
12. Below 40 kmh (25 mph), make 5 to 8 wide open throttle kick downs to 1st gear. Allow at
least 5 seconds each in 2nd and 3rd between each kick down.
13. For a specific DTC drive the vehicle to the Symptom's When Monitored/When Set conditions
to verify the DTC repair.
14. If a DTC sets during the road test, return to symptom list and follow the path. If no DTC
is set the repair is complete.
Continued
SKIS VERIFICATION
Skim, Miscellaneous, then select desired
257
VERIFICATION TESTS
APPLICABILITY
APPLICABILITY
5SPD MANUAL
TRANS
All