Chrysler PT Cruiser 2001 Service Manual Supplement page 2789

P0715-INPUT SPEED SENSOR ERROR —
TEST
3 Turn ignition off to the lock position.
CAUTION: Remove the Starter Relay from the PDC. This will prevent the
vehicle from being started in gear.
Install Transmission simulator (Miller tool #8333) and the FWD Adapter Cable
kit.(Miller tool #8333-1).
Ignition on, engine not running.
Using the Transmission Simulator, set the rotary knob to the middle (1000/3000)
position. Turn the Input/Output switch on.
With the DRBIII , observe the Input RPM and Output RPM.
Does the Input speed read 3000 RPM and the Output speed read 1250 RPM (within
50 RPM)?
Yes → Go To 4
No
4 Replace the Input Speed Sensor in accordance with the Service Information.
View repair options.
Repair
5 Turn ignition off to the lock position.
Disconnect the TCM harness connector.
Disconnect the TRS harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Input Speed Sensor Signal circuit from the TCM
connector to the Input Speed Sensor connector.
Is the resistance above 5.0 ohms?
Yes → Repair open Input Speed Sensor Signal circuit
No
6 Turn ignition off to the lock position.
Disconnect the TCM harness connector.
Disconnect the TRS harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Speed Sensor Ground circuit from the TCM connector
to the Input Speed Sensor connector.
Is the resistance above 5.0 ohms?
Yes → Repair the open Speed Sensor Ground circuit.
No
7 Turn ignition off to the lock position.
Disconnect the TCM harness connector.
Disconnect the TRS harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Input Speed Sensor Signal circuit and ground.
Is the resistance Below 5.0 ohms?
Yes → Repair Input Speed Sensor Signal circuit short to ground.
No
ACTION
→ Go To 5
Replace the Input Speed Sensor.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
→ Go To 6
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
→ Go To 7
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
→ Go To 8
Continued
41
TRANSMISSION
APPLICABILITY
All
All
All
All
All