Chrysler PT Cruiser 2001 Service Manual Supplement page 2713

VERIFICATION TESTS
Verification Tests —
Continued
POWERTRAIN VERIFICATION TEST VER - 3 APPLICABILITY
1. Inspect the vehicle to ensure that all engine components are properly installed and All
connected. Reassemble and reconnect components as necessary.
2. Connect the DRB to the Data Link Connector and erase the codes.
3. If the PCM has been replaced perform steps 4 through 6 then continue the verification.
4. If PCM has been changed and correct VIN and mileage have not been programmed, a DTC
will be set in ABS and Air bag modules. In addition, if vehicle is equipped with a Sentry Key
Immobilizer Module (SKIM), Secret Key data must be updated to enable start.
5. For ABS and Air Bag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS
and Air Bag modules.
6. For SKIM theft alarm: Connect DRB to data link conn. Go to Theft Alarm, SKIM, Misc. and
place SKIM in secured access mode, by using the appropriate PIN code for this vehicle. Select
Update the Secret Key data. Data will be transferred from SKIM to PCM.
7. Ensure no other charging system problems remain by doing the following: Start the engine.
Perform generator output per service manual.
8. Raise the engine speed to 2000 rpm for at least 30 seconds.
9. Allow the engine to idle.
10. Turn the engine off.
11. Turn the ignition key on.
12. With the DRB, read trouble code messages.
13. If repaired code has reset, or any other one has set, check all pertinent Technical Service
Bulletins and return to Symptom List if necessary.
14. If there are no codes, the repair is now complete.
253