Chrysler PT Cruiser 2001 Service Manual Supplement page 2787

Table of Contents

Advertisement

P0705-CHECK SHIFTER SIGNAL —
TEST
21
Turn ignition off to the lock position.
Disconnect the TRS harness connector.
Disconnect the TCM harness connector.
Remove the Transmission Control Relay from the PDC.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between the Fused B(+) circuit and the Trans Relay Output
circuit in the Transmission Control Relay connector.
Ignition on, engine not running.
Measure the voltage of the TRS T42 Sense circuit at the TCM connector.
Is the voltage above 1 volt?
Yes → Repair the TRS T42 Sense circuit shorted to voltage.
→ Go To 22
No
22
If there are no possible causes remaining, replace the TCM.
NOTE: Reprogram Pinion Factor and Perform Quick learn.
View repair options.
Repair
23
Check and adjust the shift linkage per the service instructions.
View repair options.
Repair
ACTION
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
Replace the TCM.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
Adjust the shift linkage per the service instructions.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
Continued
39
TRANSMISSION
APPLICABILITY
All
All
All

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents