Reinstalling The Fan Tray After Installing The Mx480 Router With A Lift - Juniper MX480 Hardware Manual

Figure 57: Reinstalling a Power Supply

Reinstalling the Fan Tray After Installing the MX480 Router with a Lift

To reinstall the fan tray (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Grasp the fan tray on each side, and insert it straight into the chassis. Note the correct orientation by
the "this side up" label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
Figure 58 on page 234):
233