Table of Contents
Advertisement
L
L-8
PROPELLER SHAFT
9TGOLX·017
9TGOLX-018
9TGOLX-019
4. Remove the companion flange with the SST.
Center bearing
Caution
• Do not damage the oil seal.
1 .. Remove the center bearing with the SST.
Inspection
Propeller shaft
Caution
• Measure the runout of No.1 and No.2 propeller
shafts.
• Replace the propeller shaft as an assembly
if
runout
is excessive.
1. Measure the propeller shaft runout with a dial indicator.
Runout: O.Smm (0.02 in) max.
Assembly Note
Center bearing
caution
• Face the oil seal breather rearward.
1. Install the center bearing onto the propeller shaft with a suita-
ble pipe and a hammer.
Pipe diameter: 45mm (1.77 in)
Advertisement
Table of Contents
Troubleshooting
