Drive Pinion; Pilot Bearing Inner Race; Rear Bearing Inner Race - Ford TRADER Workshop Manual

9TGOMX-139
9TGOMX-142
DIFFERENTIAL
M
Drive pinion
Note
• Hold the drive pinion with a hand so that it does not
fall.
1. Push the drive· pinion out of the bearing housing with the
SST and press.
Bearing outer race
1. Remove the front and rear bearing outer races with a brass
bar and a hammer.
Rear bearing inner race
1 _ Protect the drive pinion with a rag and place it in a vise.
Caution
• Do not damage the drive pinion gear with the chisel.
2. Make approx. 10mm (0.39 in) of clearance between the
drive pinion gear and the bearing inner race with a chisel.
0N
type)
3. Remove the bearing inner race with a brass bar and a
hammer.
Pilot bearing inner race (!II
type,
no stopper)
1. Protect the drive pinion with a rag and place it in a vise.
Caution
• Do not damage the drive pinion gear with the chisel.
2. Make approx. 4mm (0.16 in) of clearance between the
drive pinion and the pilot bearing inner race.
3. Remove the pilot bearing inner race from the drive pinion
with the SST.
M-31