Center Brake Shoe - Ford TRADER Workshop Manual

p
P-42
PARKING BRAKE SYSTEM
9TGOPX·111
9TGOPX·112
9TGOPX·113
Removal note
Locknut
1. Remove the locknut with the drum locked
with
the
SST.
Installation note
Center brake shoe
1. Before installation, apply grease to all sliding parts (C::::».
Inspection
Brake drum
1. Measure the brake drum inner diameter.
Standard diameter: 190mm (7.48 in)
Limit diameter : 191mm (7.52 in)
Caution
• If there are extremely uneven wear, grind (within
the
limit) or replace the drum.
2. Check the contact of drum and lining.
Apply chalk to the inside of the drum and rub the shoe
against the drum.
Note
• Check for extremely bad contact.
Caution
• H there are extremely uneven wear, grind (within
the
limit) or replace the drum.
• After the check, wipe off the chalk.
Brake shoe
1. Inspect for peeling, cracks, or abnormal wear of the. lining.
If necessary, replace the brake shoe.
2. Measure thickness of the lining. If thickness is
less
than
specified, replace the brake shoe.