Thermostat - Ford TRADER Workshop Manual

E
THERMOSTAT
THERMOSTAT
REMOVAL
I
INSPECTION
I
INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine coolant.
3. Remove in the order shown in the figure.
4. Install in the reverse order of removal.
Steps After Installation
1. Fill the radiator with the specified amount and type of engine coolant. (Refer to page E-7.)
2. Connect the negative battery cable.
3. Start the engine and check for leaks.
7.8-11
N-m---~~
(SO-110 em-kg,
69-95 in-Ib)
SEAL PRINT SIDE
FACING THE CYLINDER HEAD
®
REPLACE
®
1. Thermostat cover
2. Gasket
E-10
9TGOE2-016
9TFOEX-009
3. Thermostat
Inspection ................................... page E-10
INSPECTION
1. Visually check that the thermostat valve is airtight.
2. Place the thermostat and a thermometer in water.
3. Heat the water and check the following:
Initial-opening temperature:
80.5-83.5°C (177-182°F)
Full-open temperature:
95°C (203°F)
Full-open
lift: 8.5mm (0.33
in) min.