Master Cylinder - Ford TRADER Workshop Manual

p
MASTER CYLINDER
Removal I Installation
1 . Remove the lower panel.
BRAKE SYSTEM
2.
Remove in the order shown in the figure, referring to
Removal Note.
3. Install in the reverse order of removal, referring to
Installation Note.
4. After installation, add brake fluid, bleed air, and check for fluid leakage. (Refer to page P-6.)
Nom (m-kg,
ft-lb)
9TGOPX.026
1.
Brake pipe
Removal note .................. : ................... below
5. Master cylinder
Installation note ................................... below
2. Brake hose
3. Bolt
4. Nut
ADJUSTMENT BOLT
• I . .
. 9TGOPX'()28
P-12
Disassembly / Inspection
I
Removal note
Brake pipe
Assembly .................................. page P-14
1 . Disconnect the brake pipe from the master cylinder with the
SST. .
Caution
• Brake fluid will damage painted surfaces.
If it does get on a painted surface, wipe it off im-
mediately.
Installation note
Master cylinder
Push rod clearance
Inspection
1. Place the SST atop the master cylinder. Turn the adjust-
ment bolt until
it
bottoms in the piston.