Field Coil; Brushes And Brush Holder - Ford TRADER Workshop Manual

G
9TGOG1·041
9TGOG1·042
~
o
9TGOG1·043
9TGOO1-()44
9TGOG1·045
G-14
STARTER
4. Check the segment groove depth. If the depth of the mold
between segments is limit depth or less, undercut the
grooves by standard depth.
Standard depth: 0.5-0.Smm (0.020-0.031 in)
Limit depth: 0.2mm (O.OOS in)
Field Coil
1. Wiring damage
(1) Check for continuity between the connector and brushes
by using a circuit tester.
(2) Replace the yoke assembly if there is no continuity.
2. Ground of the field coil
(1) Check for continuity between the connector and yoke
by using a circuit tester.
(2) Repair or replace the yoke assembly if there is continuity.
3. Installation of the field coil
Replace the yoke assembly if the field coil is loose.
Brushes and Brush Holder
1 . Check for continuity between the insulated brush and the
plate with a circuit tester. Replace the brush holder if there
is continuity.
2. If the brushes are worn beyond the wear limit or if the wear
is near the limit, replace the brushes.
Limit of brush: 11 mm (0.43 in)
Note
• New one: 1Smm (0.71 in)