Cylinder Head Gasket - Ford TRADER Workshop Manual

CYLINDER HEAD GASKET
Replacement
Warning
ON-VEHICLE MAINTENANCE
• Keep sparks and open flame away from the fuel area.
Caution
B
• Position hose clamps in their original location on hoses, and squeeze the clamps lightly with
large pliers to ensure a good fit.
1. Disconnect the negative battery cable.
2. Drain the engine coolant.
3. Remove in the order shown in the figure, referring to Removal Note.
4. Install in the reverse order of removal, referring to Installation Note.
Steps After Installation
1. Fill the radiator with the specified amount and type of engine coolant. (Refer to Section
E.)
2. Connect the negative battery cable.
3. Check as follows:
(1) Engine oil and engine coolant leakage.
(2) Compression. (Refer to page 8-18.)
(3) Drive belt deflection. (Refer to page 8-8.)
4. Start the engine and let it warm up to operating temperature.
S. Recheck the engine coolant levels.
9TFOBX'()11
8-21.