Table of Contents
Advertisement
B
FRONT OIL SEAL
Replacement
caution
ON-VEHICLE MAINTENANCE
• Position hose clamps in their
original location
on hoses, and squeeze the clamps lightly with
large pliers to ensure a good fit.
• After radiator cowling installation, rotate the cooling fan by hand and verify that the fan blade
does not touch the radiator cowling.
.
If the fan touches the cowling, adjust the radiator cowling mounting position.
1. Disconnect the negative battery cable.
2. Remove the undercover.
3. Drain the engine coolant.
4. Remove in the order shown in the figure, referring to Removal Note.
5. Install in the reverse order of removal, referring to Installation Note.
9TGOB2·083
Steps After Installation
1. Fill the radiator with the specified amount and type of engine coolant. (Refer to Section E.)
2. Install the undercover.
_
3. Connect the negative battery cable.
4.
Start
the engine and check as follows:
(1) Engine oil and engine coolant leakage.
(2) Drive belt deflection. (Refer to page 8-8.) .
5. Recheck the engine coolant levels.
9TFOBX-018
8-28
Advertisement
Table of Contents
Troubleshooting
