Table of Contents
Advertisement
F3
,.;=
•
SEDIMENT
I
FL6AT LEVEL
: LINE
I
I
9TGOF3·051
AIR BLEEDER
PLUG~
,
~
9TGOF3-052
'"
FLOAT LEVEL
IR5~UNE{~
9TGOF3·053
9TFOF3·004
F3-22
FUEL SYSTEM
SEDIMENTOR
Draining Water
Note
• Drain the water when the sedimentor warning light
is illuminated or the float ring has risen near the float
level line.
1. Loosen the drain plug.
2.
Loosen the air bleeding plug.
3. When water has been drained, pump the fuel with the prim-
ing pump installed on the fuel filter.
4. Loosen the bleeder screw of fuel filter and bleed the air.
Inspection
1.
Visually check the sedimentor for damage and fuel leak-
age. Repair or replace, if necessary.
2.
Check the position of the float ring and if the ring is near
the float level line, drain the water.
SEDIMENTOR SENSOR (DETECTOR)
Inspection
1. Remove the sedimentor sensor from the sedimentor.
2.
Verify that there is continuity with ohmmeter, when the float
up.
Replacement
Warning
• Keep sparks, cigarettes and open flames away from
sedimentor.
1. Disconnect the connectors.
2. Remove the fuel hoses.
3. Remove the sedimentor.
4. Install in the reverse order of removal.
Advertisement
Table of Contents
Troubleshooting
