Overhaul - Ford TRADER Workshop Manual

H
CLUTCH RELEASE CYLINDER
I nstallation Note
Flexible hose
1. Tighten the flexible hose with the SST.
Tightening torque:
22-26 N·m (2.2-2.7 m-kg, 16-20 ft-Ib)
9TGOHX·026
OVERHAUL
Caution
Air Bleeding
1. After installation, bleed the clutch system.
(Refer to page H-10.)
• Clean the disassembled parts in solvent and blow through all ports and passages with com-
pressed air.
• Before assembly, make sure all parts are completely clean.
• Apply the specified clutch fluid to the piston and cup assembly and cylinder bore before as-
sembly.
1. Disassemble in the order shown in the figure, referring to Disassembly Note.
2. Inspect all parts and repair or replace as necessary.
3. Assemble in the reverse order of disassembly, referring to Installation Note.
1. Boot band
2. Boot
3. Push rod
4. Piston and cup assembly
Inspect for wear, scoring and cracks
5. Return spring
H-16
Nom
(m-kg, 1I-Ib)
9TGOHX·027
6. Bleeder cap
7. Bleeder screw
8. Steel ball
9. Release cylinder body
Inspect cylinder bore for scoring and
corrosion