Brush Hoder Ans Ic Regulator Assembly - Ford TRADER Workshop Manual

G
G-8
CHARGING SYSTEM
9TGOG1·017
9TGOGH)18
9TGOG1-019
9TGOG1·020
9TGOG1-021
Disassemble note I Assemble note
1. Use a soldering iron to disconnect the stator lead wiring.
Caution
• Do the disconnecting quickly, using the soldering
iron no more than about 5 seconds, because the rec-
tifier may become damaged if the inside is over-
heated.
Brush Hoder ans Ie Regulator Assembly
1. Use a soldering iron to disconnect the brush holder and
IC regulator assembly from the rectifier.
Inspection
Inspect the following parts, and repair or replace if a problem
is found.
Stator
1. Use a circuit tester to check for continuity between the core
and each lead wire.
No-continuity is the normal condition.
2. Use a circuit tester to check for continuity between lead
wires.
Continuity is the normal condition.
Rotor
1. Use a circuit tester to check for continuity beween the core
and each slip ring.
No-continuity is· the normal condition.