Steps After Installation - Ford TRADER Workshop Manual

B
INSTALLATION
Steps After Installation
1. Install the undercover.
2. If the engine oil was drained, fill with the specified amount and type of engine oil. (Refer to Section D.)
3. Fill the radiator with the specified amount and type of engine coolant. (Refer to Section E.)
4. If the transmission oil was drained, fill with the specified amount and type of transmission oil.
(Refer to Section J.)
5. Adjust the drive belt deflection. (Refer to page 8-9.)
6. Bleed the air from the fuel system. (Refer to page B-16.)
7. Bleed the air from the clutch system. (Refer to Section H.)
8. Connect the negative battery cable.
9. Start the engine and check the following.
(1) Engine oil, transmission oil, and engine coolant leakage.
(2) Injection timing, idle speed. (Refer to page B-11.)
10. Perform a road test.
11. Recheck the engine oil and engine coolant levels.
8-150
9TFOBX·052