Combustion Chamber Insert (Ha) - Ford TRADER Workshop Manual

B
9TGOB2·336
9TGOB2·337
Ipl"'t''''''
. • I
::JIHIIIliII
9TGOB2·338
97GOB2·339
B-114
ASSEMBLY
Combustion Chamber Insert (HA)
1. Place the insert into position of the cylinder head and ad-
just the position in relation to the welsh washer. .
Set the welsh washer with the projected portion directed
toward the cylinder head gasket side.
2. Calk the welsh washer by lightly striking its center with a
punch.
Valve Guide
1. Assemble the SST so that depth L is as specified.
Depth L: 15.2-1S.4mm (0.598-0.606 in)
2. Tighten the locknut.
3. Tap the valve guide in from the side opposite the combus-
tion chamber until the SST contacts the cylinder head.
4. Verify that the valve guide height is within specification.
Height: 15.2-15.4mm (0.598-0.606 in)
5. If not within specification, repeat Steps
1-4.
Valve Seal
1 . Assemble the SST so that depth L is as specified .
Depth L: 16.5-16.9mm (0.650-0.665 in)
2. Slide the valve seal onto the valve guide.
3. Set the SST against the valve seal.