Fuel Gauge Sender Unit - Ford TRADER Workshop Manual

INSTRUMENT CLUSTER (METER)
T
WITH TACHOMETER
·1530
190
I-
'1
• ~
17H
4:
TEMP
WITHOUT
TACHOMETER
J:
TEMP
1530
100
C~H
'\
~,
,
«»
4i¥-
mm (in)
AUSTRALIA
'Q
9TGOTX·133
__
.t1r.-~3Q
2n.8
(10.94)
~--+--!-32.50
"'I2-=!-_ _ _ ...l.-...l.-.1100
9TGOTX·134
4. Set the SST to the resistance values shown in the figure.
5. Turn the engine switch ON, and verify that the needle indi-
cates the correct values.
Caution
• Continue the above checks for at least two minutes
each to correctly judge the condition .
• The allowable indication error is twice the width of
the needle.
WATER THERMOSENSOR
Removal
I
Installation
1. Disconnect the connector from the water thermosensor.
2. Remove the sensor.
3. Install in the reverse order of removal.
Inspection
1. Place the water thermosensor and a thermometer in wa-
ter, and gradually heat the water.
2. Measure the resistance of the sensor with an ohmmeter.
Resistance: 190-2600 at 50°C (122°F)
3. Replace the water thermosensor if not as specified.
FUEL GAUGE SENDER UNIT
Removal
I
Installation
1. Disconnect the connector from the fuel gauge sender unit.
2. Remove the screws and remove the fuel gauge sender unit
from the fuel tank.
3. Install in the reverse order of removal.
Inspection
1. Connect an ohmmeter between the terminals of the fuel
gauge sender unit.
2. Measure the resistance while slowly moving the unit from
point E to point
F.
3. Replace the fuel gauge sender unit if not as specified.
T-71