Starter - Ford TRADER Workshop Manual

9TGOG,-032
9TGOG1-Q33
STARTER
G
STARTER
STARTER
Inspection (On-vehicle)
1. Use a fully charged battery.
2. Turn the engine switch to the start position.
3. Check that the starter operates smoothly.
4. If the starter does not operate, check the voltage between
S terminal and ground by using a voltmeter.
5. If the voltage is 8V or more, the starter is malfunctioning.
6. If less than 8V, the wiring harness is malfunctioning.
Removal
I
Installation
1. Disconnect the negative battery cable.
2. Disconnect the wiring from the starter.
3. Remove the starter bolts.
4. Draw out the starter from lower side of the vehicle.
5. Install in the reverse order of removal.
Tightening torque:
64-89 N-m (6.5-9.1 m-kg, 47---66 ft-Ib)
G-11