Bearing Outer Race (Inner) - Ford TRADER Workshop Manual

9TGOMX·099
9TGOMX·l00
9TGOMX·l02
9TGOMX·l03
REAR AXLE
Disassembly Note
Bearing outer race (Inner)
Caution
• Replace the inner and outer race as a set.
• Do not reuse the removed oil seal.
Note
M
• When removing the bearing outer race (Inner), the
inner race and oil seal will also come out.
1 . Tap the bearing outer race at the notches in the wheel hub
(shown by arrows) with a brass bar and a hammer.
Hub bolt
1. Remove the hub bolts with a brass hammer.
Assembly Note
Bearing outer race
1 . Apply grease to the new bearing outer race.
2. Install the outer race with a brass bar and a hammer.
Oil seal
1. Apply grease to the lip of the new oil seal.
2. Drive the oil seal into the wheel hub with a suitable plate
and a hammer.
3. Pack grease into the shaded areas shown in the figure.
M-19