Pre-Delivery Inspection Table - Ford TRADER Workshop Manual

A
PRE-DELIVERY INSPECTION TABLE
PRE-DELIVERY INSPECTION TABLE
I
1. EXTERIOR
I
*
INSPECT and ADJUST, if necessary, the following items to
the specifications:
o
Glass, exterior bright metal and paint for damage or rust
o
Wheel lug nuts
o
Tire pressures
o
All weatherstrips for -damage or detachment
o
Operation of tilt cab lock lever
o
Door operation and alignment
*
INSTALL the following parts:
o
Outside rearview mirror(s)
12.
UNDER HOOD-ENGINE OFF
I
",INSPECT and ADJUST,
if
necessary, tne
fOllOWing
Items to
the specifications: -
o
Fuel, coolant and hydraulic lines, fittings, connections and
components for leaks
o
Battery electrolyte level and specific gravity
o
Engine oil level _
o
Oil level in steering gearbox (Manual steering)
o
Power. steering fluid level (if equipped)
o
Brake and clutch master cylinder fluid levels
o
Windshield washer reservoir fluid level
o
Glow plugs (if equipped)
o
Radiator coolant and specific gravity
o
Tightness of water hose clamps (including heater hoses)
o
Tightness of battery terminals
o
Drive belt tensions
o
Accelerator cable and linkage for free movement
I
3. INTERIOR
I
*
INSTALL the following parts:
o
Fuse for accessories
*
CHECK
the operations of the following items:
o
Seat controls
o
Seat belts and warning system (if equipped)
o
Door locks
o
Ignition switch and steering lock
o
All lights including warning and indicator lights (if equipped)
o
Warning buzzers (if equipped)
o
Horn, windshield wipers and washers (if equipped)
o
Radio and antenna (if equipped)
o
Cigarette lighter and clock (if equipped)
o
Tilt Steering (if equipped)
o
Heater, defroster and air conditioner at various modes (if
equipped)
*
ADJUST antenna trimmer on radio Of equipped)
A-2
INTERIOR (cont'd)
*
CHECK the following items:
C Presence of spare fuse
o
Upholstery and interior finish
*
CHECK and ADJUST, if necessary, the following items:
o
Operation and fit of windows
o
Pedal height and free play of brake and clutch pedals
o
Parking brake
4. UNDER HOOD-ENGINE RUNNING AT
OPERATING TEMPERATURE
*
CHECK the following items:
o
Operation of cold start device (if equipped)
o
Idle speed
o
Injection timing
I
5. ON HOIST
I
*
CHECK the following items:
o
Rear axle oil level
o
Underside fuel, coolant and hydrauliC lines, fittings, connec-
tions and components for leaks
o
Tires for cuts or bruises
o
Steering linkage, suspension, exhaust system ar.ld all under-
side hardware for looseness or damage
o
Tighteness of cargo deck installation bolts
I
6. ROAD TEST
I
*
CHECK the following items:
o
Brake operation
o
Clutch operation
o
Steering control
o
Operation of meters and gauges
o
Squeaks, rattles or unusual noise
o
Engine general performance
o
Emergency locking retractors (if equipped)
I
7. AFTER ROAD TEST
I
*
REMOVE seat and floor mat protective covers
*
CHECK for necessary owner's information material, tools and
spare tire in vehicle
9TFOAX.()()1