Center Bearing Rubber - Ford TRADER Workshop Manual

PROPELLER SHAFT
L
9TGOLX-Q21
9TGOLX-023
9TGOLX-Q24
Center bearing rubber
Caution
• Face the oil seal breather upward.
1. Install the center bearing rubber.
Center companion flange
1 . Align the marks on the flange and shaft, and install the center
companion flange.
Bearing cup
Caution
• Do not reuse the snap ring, bearing cup, or spider.
1 . Apply lithium based grease to the bearing rollers inside the
bearing cups.
2. Clamp the yoke in a vise.
Note
• Install the spider with the grease nipple toward the
propeller shaft.
3. Set the new spider into the yoke and tap in a bearing cup
using the spider to hold the rollers.
4. Slide the yoke to the opposite side and install the other bear-
ing cup.
Snap ring
Caution
• Use only new snap rings and ones of the same
thickness.
1. Install the thinnest snap rings.
L-9