4.13
Specifying the Position from which a
Document is to be Scanned for Copy
Purposes
The normal position for starting document scanning is the top left-hand corner of the
document. This function enables the position for starting document scanning to be
changed. This is used when documents need to be copied halfway through.
When [Synchronized] has been selected for the [Media Cut Mode], the length of the
adjusted scan starting position plus the length of the document will be cut.
Up/Down
Left/Right
Direction in which
the document
is inserted
Left/Right
It moves to
the left
Document
4.13 Specifying the Position from which a Document is to be Scanned for Copy Purposes
Specifies the scan starting position within a range of 0 to +/–999 mm
in increments of 1 mm with the top edge of the document set as a
standard [0].
Specifies the scan starting position within a range of 0 to +/–999 mm
in increments of 1 mm with the top left edge of the document set as a
standard [0].
The scan starting position is set against the paper. This is not linked with the
percentage rate function.
Up/Down
It moves to
the right
Document
Scan Start Position
Standard cut
It moves up
It moves down
Synchronized cut
71