Upgrading The Scb In The Master Routing Engine - Juniper MX960 Hardware Manual

Upgrading the SCB in the Master Routing Engine

Copyright © 2017, Juniper Networks, Inc.
To upgrade the SCB in the master Routing Engine slot:
Ensure a Graceful RE Switchover (GRES) to gracefully switch between the master
1.
and backup Routing Engines, so that the backup RE becomes the master RE, by issuing
the
request chassis routing-engine master switch
Log in to the new master Routing Engine after the switchover.
2.
Switch the configuration mode to ensure that you are still in configure exclusive mode
3.
by issuing the command and then the
exit
master Routing Engine.
Log in to the current master Routing Engine again and issue the
4.
command.
Power down the backup Routing Engine from the master Routing Engine by issuing
5.
the
request system power-off other-routing-engine
Ensure that the Routing Engine is powered down by issuing the
6.
routing-engine 0 command. The slot of the Routing Engine may be 0 or 1, and is shown
as 1 in this example:
user@host> show chassis routing-engine 1
Routing Engine Status:
Slot 0:
Current State Present
Verify that the Current State is Present, which indicates that the Routing Engine is
offline or powered down.
Take the first fabric plane of the backup Routing Engine offline by issuing the
7.
chassis fabric plane offline 1
Verify that the fabric plane is offline by issuing the
8.
command.
user@host> show chassis fabric summary
Plane State Uptime
1 Offline
2 Online 3 minutes, 25 seconds
Verify that the State of Plane 1 is Offline.
Take the next fabric plane offline by issuing the
9.
command and verify that the fabric plane is offline by issuing the command given in
Step 2.
Chapter 27: Replacing Switch Fabric Components
command.
configure exclusive
command.
command.
show chassis fabric summary
request chassis fabric plane offline 0
command, from the old
configure exclusive
show chassis
request
433