Installing An Mx960 Pic - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Installing an MX960 PIC

384
To install a PIC (see Figure 103 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
2.
on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC and then slide the PIC in until it lodges firmly in the FPC.
CAUTION: Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
For an FPC3 PIC, turn the ejector handle at the top of the PIC faceplate clockwise,
4.
then tighten the captive screw at the bottom of the faceplate to secure the PIC in the
FPC.
If the PIC uses fiber-optic cable, remove the rubber safety cap from each transceiver
5.
and the end of each cable.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
Insert the appropriate cables into the cable connectors on the PIC.
6.
Arrange the cable in the standard or extended cable manager to prevent it from
7.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop. Placing fasteners on the loop helps to maintain its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
288):
Copyright © 2017, Juniper Networks, Inc.