MX960 3D Universal Edge Router Hardware Guide
Removing the DPCs Before Installing an MX960 Router with a Lift
210
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Repeat the procedure for each SCB.
6.
Figure 59: Removing an SCB
To remove a DPC (see
Figure 60 on page
Have ready an antistatic mat for the DPC. Also have ready rubber safety caps for each
1.
DPC using an optical interface on the DPC that you are removing.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Simultaneously turn both the ejector handles counterclockwise to unseat the DPC.
3.
211):
Copyright © 2017, Juniper Networks, Inc.