Figure 182: Mx960 With High-Capacity Dc Power Supplies Installed - Juniper MX960 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
To install an MX960 DC high-capacity DC power supply:
Verify that the power switch on the power supply is in the off (
1.
On the power supply, rotate the metal cover away from the input mode switch to
2.
expose the switch.
Move the input mode switch to position 0 for one feed or position 1 for two feeds (see
3.
Figure 74 on page 237).
NOTE: For a fully redundant configuration in two-feed mode, eight feeds
are required. For a nonredundant configuration, four feeds are required.

Figure 182: MX960 with High-Capacity DC Power Supplies Installed

CAUTION: Do not use a pencil, because fragments can break off and cause
damage to the power supply.
Chapter 30: Converting to a Different Type of Power Supply
1
0
) position.
O
475