Mx960 Scbe Leds; Table 61: Mx Scbe Leds - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

MX960 SCBE LEDs

112
Switch fabric—Provides the switching functions for the DPCs, FPCs, and MPCs
Control field-programmable gate array (FPGA)—Provides the Peripheral Component
Interconnect (PCI) interface to the Routing Engine
1000Base-T Ethernet controller—Provides a 1-Gbps Ethernet link between the Routing
Engines
Circuits for chassis management and control
Power circuits for the Routing Engine and SCBE
LEDs—Provide status of the SCBE and clocking interface
MX960 SCB Description on page 107
MX960 SCBE LEDs on page 112
Upgrading an MX960 SCB to SCBE on page 413
The ,
FABRIC ACTIVE FABRIC ONLY
SCBE. The , , and
BITS GPS
of the respective clocking interface.
MX SCBE LEDs.

Table 61: MX SCBE LEDs

Label Color
Green
FABRIC
ACTIVE
Green
FABRIC
ONLY
–
OK/FAIL Green
Red
–
Red
–
NOTE: The LEDs , , and
BITS GPS
, and LEDs indicate the status of the MX
OK/FAIL
LEDs, located next to the
UTI
Table 61 on page 112
State Description
On steadily Fabric is in active mode.
On steadily MX SCBE operates in fabric-only mode.
Off MX SCBE operates in fabric/control board mode.
On steadily MX SCBE is online.
On steadily MX SCBE has failed.
Off MX SCBE is offline.
On steadily GPS clocking interface has failed.
Off GPS clocking interface is offline.
are not currently supported.
UTI
port, indicate the status
EXT CLK
describes the functions of the
Copyright © 2017, Juniper Networks, Inc.