Replacing An Mx960 Fan Tray; Removing An Mx960 Fan Tray; Figure 126: Installing The Air Filter - Juniper MX960 Hardware Manual

Related
Documentation

Replacing an MX960 Fan Tray

Removing an MX960 Fan Tray

Copyright © 2017, Juniper Networks, Inc.
Insert the air filter tray into the chassis by sliding it straight into the chassis until it
4.
stops.
Lower the cable manager back into position.
5.
Rearrange the cables in the cable manager.
6.

Figure 126: Installing the Air Filter

Preventing Electrostatic Discharge Damage to an MX960 Router
Maintaining the MX960 Air Filter on page 446
Removing an MX960 Fan Tray on page 327
1.
Installing an MX960 Fan Tray on page 329
2.
NOTE: To prevent overheating, install the replacement fan tray immediately
after removing the existing fan tray.
To remove the upper or lower fan tray (see
Figure 128 on page 329):
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Reposition the standard cable manager before removing the lower front fan tray:
2.
NOTE: This step is not required for the extended cable manager.
Unwrap any cables on the standard cable manager and remove the cables from
a.
the tray. Arrange the cables so that they do not block the front of the cable manager
and tray, and secure them with temporary fasteners so that they are not supporting
their own weight as they hang from the connector.
Chapter 23: Replacing Cooling System Component
Figure 127 on page 328 and
327