Figure 179: Standard Cable Manager; Figure 180: Extended Cable Manager - Juniper MX960 Hardware Manual

Action
Copyright © 2017, Juniper Networks, Inc.
On a regular basis:
Use a standard cable manager or extended cable manager (shown in
Figure 179 on page 467 and
from dislodging or developing stress points.

Figure 179: Standard Cable Manager

Release handles

Figure 180: Extended Cable Manager

Place excess cable out of the way in the standard or extended cable manager. Do not
allow fastened loops of cable to dangle from the connector or cable manager because
this stresses the cable at the fastening point. Putting fasteners on the loops helps to
maintain their shape.
Keep the cable connections clean and free of dust and other particles, which can cause
drops in the received power level. Always inspect cables and clean them if necessary
before connecting an interface.
Label both ends of the cables to identify them.
Figure 180 on page 467) to support cables and prevent cables
Maintenance linkage
Chapter 29: Maintaining Components
467