Removing the SCBs Before Installing an MX960 Router with a Lift
Copyright © 2017, Juniper Networks, Inc.
Figure 58: Removing a Lower Fan Tray
To remove the SCBs (see
Figure 59 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
3.
Grasp the ejector handles, and slide the SCB about halfway out of the chassis.
4.
Place one hand underneath the SCB to support it, and slide it completely out of the
5.
chassis. Place it on the antistatic mat.
Chapter 16: Installing the MX960 Router
210):
209