Installing an MX960 SCB
Copyright © 2017, Juniper Networks, Inc.
Place the SCB on the antistatic mat.
8.
If you are not replacing the SCB now, install a blank panel over the empty slot.
9.
Figure 169: Removing an SCB
To install an SCB (see
Figure 110 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Carefully align the sides of the SCB with the guides inside the chassis.
2.
Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is
3.
correctly aligned.
Grasp both ejector handles, and rotate them simultaneously clockwise until the SCB
4.
is fully seated.
Chapter 27: Replacing Switch Fabric Components
304):
411