Juniper MX960 Hardware Manual page 306

MX960 3D Universal Edge Router Hardware Guide
276
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Insert the appropriate cable into the cable connector ports on each PIC on the FPC.
12.
Arrange the cable in the standard or extended cable manager to prevent it from
13.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop. Placing fasteners on the loop helps to maintain its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the FPC online:
14.
Press and hold the FPC online/offline button until the green
button lights steadily, in about 5 seconds. The LEDs and online/offline button for
each FPC are located directly above it on the craft interface.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
CAUTION: After the
removing the FPC again, removing an FPC from a different slot, or inserting
an FPC in a different slot.
You can also verify correct FPC and PIC functioning by issuing the
show chassis fpc pic-status
and "Maintaining MX960 PICs" on page
LED lights steadily, wait at least 30 seconds before
OK
commands described in "Maintaining MX960 FPCs" on page 455
466.
LED next to the
OK
.
CLI Explorer
show chassis fpc
Copyright © 2017, Juniper Networks, Inc.
and