MX960 3D Universal Edge Router Hardware Guide
Table 101: MX960 High-Capacity DC Power Supply LEDs (continued)
Connected Inputs
INP0 connected, INP1 disconnected
INP0 disconnected, INP1 connected
INP0 connected, INP1 connected
Related
Documentation
Converting from DC to AC Power Supplies on an MX960 Router
478
LEDs
DIP
Switch
Position
INP-0 OK
1 (2
Green
inputs)
Off
Green
Repeat steps 1-17 for installing power supplies in slots 1, 2, and 3, where present.
18.
Figure 183: MX960 DC High-Capacity Power Supply Front View
Install a blank panel over the power distribution modules, if available.
19.
MX960 Power System Overview on page 97
Troubleshooting the MX960 Power System on page 498
The conversion of an MX960 router from AC to DC or DC to AC should be performed with
the system completely powered off. A system cannot operate with a mix of AC and DC
power supplies. This procedure assumes conversion from normal-capacity power supplies
to high-capacity power supplies.
INP-1 OK
DC OK
Off
Off
Green
Off
Green
Green
Copyright © 2017, Juniper Networks, Inc.
PS FAIL
Red
Red
Off