Replacing The Console Or Auxiliary Cable On An Mx960 Router; Figure 115: Removing The Standard Cable Manager - Juniper MX960 Hardware Manual

3d universal edge router

Hide thumbs Also See for MX960:

Table of Contents

Documentation

Replacing the Console or Auxiliary Cable on an MX960 Router

To install the standard cable manager (see

Position the standard cable manager on the studs on the lower front of the chassis.

Insert the nuts on the corners in the standard cable manager onto the studs on the

Using a 7/16-in. (11 mm) nut driver, tighten the nuts securely.

Preventing Electrostatic Discharge Damage to an MX960 Router

MX960 Cable Manager Description on page 19

Verifying the Version of the MX960 Cable Manager on page 469

To use a system console to configure and manage the Routing Engine, connect it to the

port on the Routing Engine. To use a laptop, modem, or other auxiliary device,

connect it to the

port on the Routing Engine. Both ports accept a cable with an RJ-45

Chapter 22: Replacing Chassis Components

Figure 115 on page

Show Quick Links

Table of Contents